Skip to main navigation menu Skip to main content Skip to site footer

Articles

Vol. 6 (2019)

Effect of the Interfacial Slippage on the Moving Surface in a Hydrodynamic Step Bearing

DOI
https://doi.org/10.31875/2409-9848.2019.06.6
Submitted
July 17, 2019
Published
2019-07-17

Abstract

The effect of the interfacial slippage on the moving surface in a hydrodynamic step bearing is analytically investigated based on the interfacial limiting shear strength model. The calculation results show that when the interfacial slippage occurs on the whole moving surface but is absent on the whole stationary surface, the load-carrying capacity of the bearing is independent on the sliding speed but is intimately dependent on the contact-fluid interfacial shear strength on the moving surface, and the carried load of the bearing is normally heavily reduced as compared to that calculated from conventional hydrodynamic lubrication theory especially for high sliding speeds; The friction coefficient of this mode of bearing is significantly higher than that of the conventional hydrodynamic step bearing for a high sliding speed, but the case is opposite for a low sliding speed. The results show the potential application value of this mode of bearing for reducing the friction at a low sliding speed or the necessity of preventing the occurrence of the interfacial slippage on the moving surface in a hydrodynamic step bearing at a high sliding speed.

References

  1. Schnell E. Slippage of water over nonwettable surfaces. J Appl Phys 1956; 27: 1149-1152. https://doi.org/10.1063/1.1722220
  2. Churaev NV, Sobolev VD, Somov AN. Slippage of liquids over lyophobic solid surfaces. J Colloid Interface Sci 1984; 97: 574-581. https://doi.org/10.1016/0021-9797(84)90330-8
  3. Craig VSJ, Neto C, Williams DRM. Shear-dependent boundary slip in an aqueous Newtonian liquid. Phy Rev Lett 2001; 87: No.054504. https://doi.org/10.1103/PhysRevLett.87.054504
  4. Thompson PA, Troian SM. A general boundary condition for liquid flow at solid surfaces. Nature 1997; 389: 360-362. https://doi.org/10.1038/38686
  5. Pinkus O, Sternlicht B. Theory of hydrodynamic lubrication, McGraw-Hill, New York 1961.
  6. Zhang YB. A molecular calculation of the solid-liquid interfacial shear strength for low liquid pressures by using the Lennard-Jones potential model. J Balkan Trib Assoc 2014; 20: 618-629.
  7. Zhang YB. A molecular calculation of the solid-liquid interfacial shear strength for low liquid pressures by using the Coulomb interaction model. J Balkan Trib Assoc 2015; 21: 594-605.
  8. Rozeanu L, Snarsky L. The unusual behavior of a lubricant boundary layer. Wear 1977; 43: 117-126. https://doi.org/10.1016/0043-1648(77)90047-3
  9. Rozeanu L, Snarsky L. Effect of solid surface lubricant interaction on the load carrying capacity of sliding bearings. ASME J Lubri Tech 1978; 100: 167-175. https://doi.org/10.1115/1.3453130
  10. Rozeanu L, Tipei N. Slippage phenomena at the interface between the adsorbed layer and the bulk of the lubricant: Theory and experiment. Wear 1980; 64: 245-257. https://doi.org/10.1016/0043-1648(80)90131-3
  11. Chen HJ, Zhang YB. Investigation of the performance of hydrodynamic journal bearing with slippage shaft surface. J Balkan Trib Assoc 2019. https://doi.org/10.1080/14484846.2019.1587812
  12. Jacobson BO, Hamrock BJ. Non-Newtonian fluid model incorporated into elastohydrodynamic lubrication of rectangular contacts. ASME J Trib 1984; 106: 275-284. https://doi.org/10.1115/1.3260901
  13. Lee R, Hamrock BJ. A circular non-Newtonian fluid model Part I: Used in EHL. ASME J Trib 1990; 112: 486-490. https://doi.org/10.1115/1.2920285
  14. Shieh J, Hamrock BJ. Film collapse in EHL and micro-EHL. ASME J Trib 1991; 113: 372-377. https://doi.org/10.1115/1.2920631
  15. Salant RF, Fortier AE. Numerical analysis of a slider bearing with a heterogeneous slip/no-slip surface. Trib Trans 2004; 47: 328-334. https://doi.org/10.1080/05698190490455348
  16. Zhang YB. A tilted pad thrust slider bearing improved by the boundary slippage. Meccanica 2013; 48: 769-781. https://doi.org/10.1007/s11012-012-9630-6
  17. Zhang YB. Boundary slippage for improving the load and friction performance of a step bearing. Trans Can Soc Mech Eng 2010; 34: 373-387. https://doi.org/10.1139/tcsme-2010-0022
  18. Zhang YB. Boundary slippage for generating hydrodynamic load-carrying capacity. Appl Math Mech 2008; 29; 1155- 1164. https://doi.org/10.1007/s10483-008-0905-y
  19. Zhang YB. A concentric hydrodynamic journal bearing constructed by the boundary slippage. J Theor Appl Mech Warsaw 2016; 54: 345-352. https://doi.org/10.15632/jtam-pl.54.2.345
  20. Cheng HS, Zhang YB, Tang ZP, Dong YW, Pan LZ. Abnormal hydrodynamic inclined fixed pad thrust slider bearing formed by boundary slippage. J Balkan Trib Assoc 2018; 24: 64-74.
  21. Wang JY, Zhang YB, Pan LZ, Dong YW, Tang ZP. Abnormal hydrodynamic step bearing formed by boundary slippage. J Balkan Trib Assoc 2018; 24: 75-85.
  22. Li L, Wang H, Pang MJ, Jiang X, Zhang YB. A wedgeplatform thrust slider bearing improved by the boundary slippage. J Balkan Trib Assoc 2016; 22: 751-765.
  23. Guan LY, Zhang YB. Performance of a hydrodynamic step bearing with the boundary slippage on both the stationary contact surface in the inlet zone and on the whole moving contact surface. JBTA 2018; 24(3): 531-541.
  24. Xia YT, Zhang YB, Wang Y, Jiang XD, Dong YW. Hydrodynamic wedge-platform thrust slider bearing with the interfaical slippage on the whole moving surface. J Balkan Trib Assoc 2019; 25(2): 392-401.
  25. Cheng HS, Zhang YB, Dong YW, Jiang XD, Wang Y. Investigation on the influence of the interfacial slippage on the whole moving surface in an inclined fixed pad thrust slider bearing. J Mod Mech Eng Tech 2019; 6: 4-9.
  26. Zhang YB. Review of hydrodynamic lubrication with interfacial slippage. J Balkan Trib Assoc 2014; 20: 522-538.
  27. Zhang YB, et al. An analysis of elastohydrodynamic lubrication with limiting shear stress: Part I-Theory and solutions. Trib Trans 2002; 45: 135-144. https://doi.org/10.1080/10402000208982532